Comcast Xfinity XR2 - Remote Control Start Manual (2024)

Contents

1. To set up your remote, first install AA batteries (sold separately). The All Power key will blink green four times as the remote powers up (about 5 seconds).
   
2. Turn on your TV.
3. Turn on your cable box.
   

1. Press the Setup button until the All Power key on the remote changes from red to green.
2. Press B for control of a Motorola brand cable box; press C for control of a Cisco or Scientific-Atlanta brand cable box.
   Note: If you need to re-program the remote for control of an XFINITY cable box, repeat the steps above and press A in step 2.
3. Press the XFINITY key to check that your remote controls your set-top box. If it does, you're all set. If not, repeat these steps but press C for Cisco mode or A for XFINITY mode in step B.
   Once the code is correctly entered, your XFINITY Remote is paired with the device.
   

1. Press the Setup button until the All Power key on the remote changes from red to green.
2. Press the XFINITY button.
   
3. Follow the on-screen instruction to enter the 3-digit code that appears.
   Once the code is correctly entered, your XFINITY Remote is paired with the device.
   
   Not working? Make sure to install batteries in the remote, check that your TV is on and that you are entering the correct 3-digit code on your TV screen.
   Need to remove Aim Anywhere control? Press and hold the Setup button on the remote until the status LED changes from red to green. Press A on the remote. If the status LED blinks green twice, you have successfully removed Aim Anywhere.

1. Using the list on the right, find the first 5-digit code for your TV manufacturer.
2. Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
   
3. Enter in the first 5-digit code for you TV manufacturer. The Status LED should blink green twice.
   
4. Verify that the code was accepted by using your remote to adjust volume and turn the TV on and off.